w = Request Upper Distance Limit
The ASCII command w is used to send and display the upper distance limit
configured using the h command.
Type character w, then ENTER.
The upper distance limit value set using the command h is displayed at the computer.
x = Send Distance Value
The ASCII command x is used to send the current distance value. The computer will
display the current distance value when the x command is entered.
Type character x, then ENTER.
The instantaneous distance value is displayed at the computer.
y = Stop Sending Continuous Distance Values
The ASCII command t is used to request that distance values be continuously
transmitted to the computer. Distance values are transmitted continuously. Select
command y to stop the continuous transmission.
Type character y, then ENTER.
The continuous display of Distance (D) results is stopped.
z = Zero (Reset) the Distance Value
The ASCII command z is used to reset or zero the distance value.
Type character z, then ENTER.
The Distance (D) result is reset to zero.
CS User Manual
121
To Next Page
Loading...
