10.9 TEST FILE
MAINTENANCE
The test files are stored in the internal memory and all testing is performed using these files.
The test setups may also be backed up or transferred to another CS Force Tester if required
as shown in the following sections.
All file maintenance is accessed using the "TEST SELECTION” screen and can only be
performed by a "Supervisor".
This screen will display the "INSTALL" button at the bottom of the screen but the additional
buttons shown below will be displayed if one of the test files is selected.
10.10 COPY
A TEST
This feature is useful if a similar test file is required for 2 or more products. Create the test
file with a suitable name for the first product, e.g. "Rubber Seal Type A". Display the "TEST
SELECTION” screen, press on the test file Icon to select it then press on the "COPY" button.
The "TEST SETTINGS" screen is displayed with a "Default" Test Name of "Copy of"
followed by the original test name, e.g."Copy of Rubber Seal Type A".
Change the Test Name to suit the product, e.g. "Rubber Seal Type B" then step through all
the screens by pressing on the "NEXT" button then finally press the "FINISH" button. This
test will then be available ready for use.
Note that the test settings can be changed during this process if the test file is similar to, but
not identical to, the original file.
Also note that if a "Favorite" test is copied, then the new test will also be marked as a
"Favorite" unless there are already 10 "Favorite" files.
10.11 EDIT
A TEST
This feature is useful if an existing test requires modification, e.g. change the test speed.
WARNING! All data in the test file will be deleted by this procedure
so if the previous test data is required, open the file then print and/or
export the data before using this feature.
96 CS User Manual
To Next Page
Loading...
Need help?
General
