The “ARCHIVE RESULTS” button will export the all batch test results to the location
identified in the export set up screen and then will clear the all the runs from the test.
10.4 DATA TABLE AND STATISTICS
The "Graph" area normally displays the last test graph during the testing sequence but can
also display a table of test results or the calculated test statistics by using the “VIEW” buttons
on the right hand side of the screen.
A table of test results is displayed by pressing on the "DATA TABLE" button.
The data table shown above displays the measured results for every test. The values are
displayed in either red, yellow or green depending upon the pass/fail criteria for each test.
The yellow color represents an excluded test run.
A table of test statistics is displayed by pressing on the "STATISTICS" button.
86 CS User Manual
To Next Page
Loading...
