90 2014-07-30 127139 13
4.11.6 Saving a setup
Saving a setup saves parameters in the Setup menu.
Access the Instrument Settings menu by selecting
“Load/Save
1
” from the Calibrator Setup menu.
The Instrument Settings are displayed.
Select a register number to be used for saving.
The setup will be saved with the selected register number.
Note…
In the Calibrator Setup the following parameters will not be
saved:
Min SET temp
Max SET temp
SENSOR visible
You can save up to 10 setups.
When the setup is saved the parameters are visible in the
right side of the screen.
To Next Page
Loading...
