92 2014-07-30 127139 13
4.11.8 Resetting the instrument setup to factory defaults
Resetting to the factory default settings changes the active setup to the
initial settings.
4.11.9 Network Configuration (for service use only)
Access the Network Configuration function by selecting
“Network
2
” from the Calibration Setup menu.
The Network Configuration screen is displayed.
When DHCP is set to Enabled, the IP address will be
updated when leaving the network menu.
When DHCP is disabled, you can configure the IP-settings
manually using the NUMERIC keys.
To Next Page
Loading...
Need help?
General
