Maintenance 113
1201281 A | 24.07.2013
9.13.7
Travel pressure check
D611904
588D112
0
I
II
III
P
611A114
611A119A
1
Travel pressure check
The drive of the vehicle can also be controlled with
brakes applied. Although it is impossible in normal
operation, this option can be activated by the X8
connector.
Required material:
A jumper for the connector X8.
Order number: 4-37570
Note
You can temporarily also use a piece of wire.
Travel pressure check procedure
Remove the cover on the steering pillar.
Turn the key to the "I" position.
Switch off the ignition by turning the key to the "0"
position. Turn the key back to the "I" position.
Start the engine by turning the key to the "III"
position.
Now connect two contacts using the X8 connector.
Apply the parking brake by pressing the parking
brake switch (1).
A brake indicator lamp starts flashing on the
display unit.
You can drive a braked machine.
To exit this mode, remove the jumper at X8.
CAUTION
!
This activation will cause a high mechanical and hydraulic
load of the machine. Ensure a suitable safe distance in front
of the machine, behind the machine as well as on its sides.
To Next Page
Loading...
