Ammann ARX 16 - Replacing Bulbs at the Rear; Gas Strut

130 ARX 1
1201281 A | 24.07.2013
10.3.2 Replacing bulbs at the rear
At the rear, you have direct access to the work light (1) and the tail lights (2).
Fig. 10-8 Work light / tail light
Work light 1 Remove the entire work light from the water tank.
2 Remove the plug from the rear of the lamp unit.
3 Remove the guard.
4 Press on the end of the securing clip to remove it.
5 Replace the defective bulb with a new one of the same type and power.
6 Put the guard back on the casing.
NOTE The guard must sit firmly on the glass body of the low beam headlight unit in
order to prevent water from entering.
Tail light 1 Remove the lamp housing.
1.1 To do so, undo the screw in the center of the housing.
2 Replace the defective bulb with a new one of the same type and power.
10.4 Gas strut
Gas struts are maintenance-free! They require no maintenance such as lubrication.
They are designed for the respective requirements and work trouble-free for many
years.
2
1