Operation 63
1201281 A | 24.07.2013
7.7 Turning off the engine
1 Put the operating lever into neutral position.
The roller is automatically hydrostatically braked.
2 Move the speed adjusting lever downward into the idle position.
3 Turn the ignition key:
4a to position 0: The engine stops.
4b to position P: The parking lights will be switched on.
NOTE The hazard warning light can be switched on and off independently of the
ignition key position.
7.8 Parking brake
Parking brake
All rollers are equipped with a parking brake switch. This switch activates the parking
brake compulsorily. In this condition, the roller neither be moved nor can the vibration
be activated. This function can be used to prevent the roller from slowly rolling on
slopes.
The driver must activate the parking brake when leaving the roller.
NOTE Increased parking brake wear.
• The parking brake may not be activated while driving, but only when the
roller is at a standstill.
7.9 Seat switch
The roller can only be put into operation when the seat switch is closed, i.e. the driver
is seated on the driver's seat.
7.9.1 Opening the seat switch
If the seat switch is opened during operation (the driver stands up), the roller will stop
after a brief delay of 0.7sec.
DANGER
Rollover hazard when driving the roller!
The seat switch must not be shorted.
• The seat switch must not be actuated by any other means than
by the driver sitting on the seat.
To Next Page
Loading...
