134 ARX 1
1201281 A | 24.07.2013
11.1 Storage
11.1.1 Short-term storage
● Put the operating lever into neutral position.
● Secure the roller from unauthorized start-up and unintentional rolling away.
● Remove the ignition key.
11.1.2 Long-term storage
Tab. 11-1 Long-term storage
11.2 Winterization (risk of freezing)
The purpose of winterization is to ensure that cold air temperatures of below 0 °C do
not damage the sprinkler system.
Component precautions Chapter
Diesel engine Observe the information in the "Long-term storage" section in the diesel
engine manual.
Fuel (diesel) Drain. 9.8.3
Battery cut-off
switch
If the roller is not in operation for more than two days, the battery must be
turned off at the battery cut-off switch. This reduces the risk of battery
discharge.
If no battery cut-off switch is fitted to your roller, remove the negative battery
cable from the battery if a standstill period of more than two weeks is
expected.
8.14
Battery Uninstall the battery and clean the outside.
Charge the battery once a month during standstill time.
10.1
Air filter unit,
exhaust pipe
Cover the air filter unit or its intake opening and the exhaust pipe with
adhesive tape. This prevents moisture from getting into the engine.
Hydraulic oil level Drain the hydraulic oil completely. Fill up the hydraulic oil tank with fresh oil
when putting the machine back into operation.
9.10
Steering cylinder Lubricate the bearings of the steering knuckle and the front bearing of the
steering cylinder with grease.
Lubricate the piston rod of the steering cylinder with grease guard.
9.14
Tires Only combined rollers have tires.
Relieve the pressure in tires (pneumatic wheels) if the machine is not being
used for a prolonged period by relieving the pneumatic wheel axis with a
wooden wedge so as to avoid flat spotting damage to the tires.
To Next Page
Loading...
