2.7. Machine control and use
! CAUTION !
Indicator lamp will light up and acoustic signal
will be heard with Rollers equipped with ROPS2D
and driving across a slope with gradient over 12.
Vibration will cut o if Roller bank increases to 15°.
! CAUTION !
If Driver stands up from the seat while driving the
speed will slow down until Roller is fully stopped
and braked, this will last 4 seconds. Following next
4 sec. the engine shuts down.
To start the engine again the Driver must sit down
again, shift the travel actuator to neutral, turn ON
brake switch, turn ignition key to “0” position and
then start the engine. Driver must brake o before
starting to move.
If Driver sits down again before 4 sec. have elap-
sed, then the Roller will continue driving at a speed
selected.
If Driver sits down after 4 sec. have elapsed, then
the engine will shut down, the Driver may start mo-
ving it again. Before that the Drives must shift the
controller to neutral, and select again the original
driving direction.
To Next Page
Loading...
