Ammann ASC 110 - Page 98

92 ASC 110
2.9. Special conditions of the Machine use
When braking o the gearbox, hydro mo-
tors and short-circuiting the hydraulic
loop of the travel, it will not be possible
to use operating, emergency or parking
brakes! All brakes are now disabled!
Due to the seepages the pressure may
drop when towing; check brakes do not
heat up due to insucient braking o.
When towing, please use undamaged
towing cable or pull rod of sucient
loading capacity 1,5 higher than the
weight of hauled Machine. It is forbid-
den to use a chain for hauling.
No person may stay on a towed Machine
where engine does not work.
It will be necessary to maintain minimal
deection from direct angle of hauling.
Max deection will be possible within
angle of up to 30°.
It will be required to keep moving con-
tinuously when hauling. Do NOT ex-
ceed hauling speed of over 2 km/hr. (1.2
mph).
The machine should only be towed for
the shortest possible distance – to ex-
tricate the machine if it gets stuck or is
blocking trac in case of breakdown.
Do not tow the machine for a longer dis-
tance than 300 m (0.19 mi).
The hauling machine shall t with its
size the Machine broken. It shall have
sucient hauling force (performance),
weight and brake eect.
When hauling downhill with the help of
cable it will be necessary to attach next
hauling machine to the rear part of the
Machine broken. In this way it will be
possible to avoid uncontrolled motion
of the Machine damaged.
Do NOT start the engine when towing
the Machine.
A sunk Roller can be hauled for a short
distance if its engine is running and
the drive and steering work. Driver on
hauled Roller must steer the Roller in
hauling direction.
Unless the engine works, measures have
to be taken to avoid any damage to the
steering, drive and brake that are not
eective.
These are general requirements for safe hauling of a broken •
Machine under normal conditions. Any and all dierent situ-
ations that may occur while hauling, shall be discussed with
the dealer.