118 ASC110/ASC130/ASC150/ASC200/ASC250
2.9. Using the machine under special conditions
1
2
Draining:
• Secure the drum by scotch blocks from both sides, lift
the rear part of the roller and release brake of wheel
hydromotors, see chapter 2.9.1.
• Rotate tyres so that valves (1) are at top positions.
Unscrew valves. Warning! The solution will squirt out
at unscrewing. Unscrew caps (2).
• Screw the filler into the opening see gr. 635 Parts
katalogue.
• Rotate tyres so that fillers are at bottom positions.
• Apply a hose with pressured air to inflation valve and
inflate until the solution stops draining.
• After draining tyres, unscrew fillers and screw in val-
ves and caps again.
• Inflate tyres to the prescribed pressure.
• Activate brakes - see chapter 2.9.1.
! NOTE !
Use safety goggles (safety shield) and rubber
gloves.
To Next Page
Loading...
