Ammann ASC 130 - Safety Standards at Lubrication and Maintenance; Safety During Maintenance; Fire Safety During Changing Contents

125ASC110 / ASC130 / ASC150
3.1. Safety Standards at Lubrication and Maintenance
3.1.1. Safety during maintenance
Lubrication, maintenance and adjustment process:
• use qualified personnel.
• according to safety instructions in the Operating ma-
nual for the vibration roller.
• according to intervals in the lubrication table accor-
ding to working hours.
• on machine placed on a flat, firm surface, secured
against spontaneous movement (with blocks) and
with steering locked.
• with disconnected electric wires and with the starting
key taken out.
• with the machine parts cooled off.
• after cleaning the machine, the lubricating and main-
tenance points, and spots to be repaired.
• with proper undamaged tools.
• by replacing parts with new original ones. The manu-
facturer cannot be responsible for damages caused by
using different units or parts.
• under proper illumination of the machine when wor-
king at reduced visibility or at night
• in case the work involves removing covers and safety
cartridges, reassemble them after completing the work
• retighten bolts with applicable torque and check tight-
ness of the joints.
• pay attention not to get burnt after heating up fluids -
use recommended fills.
Operations performed while the engine
is running (adjusting) must be perfor-
med with another person present. This
person must have immediate access to
the emergency stop and must be in
permanent communication contact
with the adjusting person so that the
engine can be stopped immediately, if
necessary.
3.1.2. Fire safety during changing contents
• From fire safety point of view, inflammable liquids
used in the machine are classified into following clas-
ses:
II class of fire danger - Diesel
IV. class of fire danger - mineral oils, lubrication gre-
ases
• The location of oil change operation must not conflict
with places subject to explosion or fire hazard.
• It must be marked by tables and signs prohibiting
smoking and open flame.
• The manipulation area must be of such design and
dimensions so that it can contain the amount of inflam-
mable liquid equal to the content of the largest tank or
transport package.
• The site must be equipped with portable fire extinguis-
hers.
• Metal barrels, canisters or tin cans should be used for
handling oils or Diesel fuel.
• Transport containers must be duly closed while being
stored.
• The containers must have one opening, they must
always be stored with the opening upside and secured
against leaks.
• The containers must be marked by permanent signs
showing the content and the class of fire danger.