87ASC110/ASC130/ASC150/ASC200/ASC250
OPERATING INSTRUCTIONS
2.7.2. Travel and reversing without
vibrations
Give the acoustic signal before
starting driving the machine and wait
for period sufficiently long for all
persons being able to leave the area
around the machine (area under the
machine) in time!
Make sure that the area in front and
in the back of the machine is free and
that no persons are present in this
area!
• Turn off gear selector (2) to set the working gear mode.
• Select appropriate range of working gear on the wor-
king gear pre-selector (3).
• Turn off the IDLE switch (15). Use selector (8) to adjust
appropriate engine speed - approx. 1800 rpm.
• Check whether vibration is not on - the signal lamp (28)
must not be on; use switch (6) to turn it off.
• Release brakes of the machine with a switch (4).
Signal lamp will go off.
To Next Page
Loading...
