Ammann ASC 130 - Every 2000 Hours or Every 2 Years; Exchanging Hydraulic Oil and Filter; Oil Exchange in the Vibrator

166 ASC110 / ASC130 / ASC150
3.6. Individual Operations of Maintenance
2
1
3
• Let oil drain into a prepared vessel - the total amount
of oil is approximately 73 l (19.3 US gal).
• Dismantle the cover.
Every 2000 Hours or Every 2 Years
3.6.28. Oil exchange in the vibrator
• Place the roller onto a flat, firm surface so that the drain
plug on the left side of the drum (3) is in the lowest
position and the opposite filling plug (1) in the highest
position.
Every 2000 Hours or Every 2 Years
• Put appropriate vessel under the drain plug.
• Unscrew all plugs and let oil drain.
• Mount the drain plug after draining is finished.
• Refill recommended oil to the edge of the checking
opening (2) through the filler (1).
• Mount remaining plugs.
! NOTE !
Change oil when it is warm.
Let drained oil cool down to less than
50 °C (122 °F).
Avoid leakage of oil to the soil.
3.6.29. Exchanging hydraulic oil and filter
! NOTE !
Exchange oil before the season or after longer
downtime of the machine. Clean together a suction
basket see chapter 3.6.30.
• Place the roller onto a flat, firm surface.
• Stop the engine and disconnect electric system.
• Fit the hose to the drain cock.