167ASC110 / ASC130 / ASC150
MAINTENANCE MANUAL
4
3
Every 2000 Hours or Every 2 Years Every 2000 Hours or Every 2 Years
• Dismantle suction hose.
• Dismantle cover with suction strainer.
• Dismantle the suction strainer from the suction pipe.
Wash the suction strainer and blow the strainer with
pressure air from inside.
• Check the condition of the suction strainer; replace the
strainer in case of damaged filter part.
• Check the inside of the tank. Carefully clean the bot-
tom and flush it with new oil if there are any impurities
on the bottom.
• Reassemble and wipe the ”O” ring with clean oil.
NOTE
For easier cleaning it is possible to dismantle the whole
upper cover (3) with the filler (4). If you dismantled the
whole upper cover (3), use a new teflon sealing strip.
Drain oil after it has cooled down below
50 °C (122 °F).
Follow the fire safety measures!
After disconnecting the hydraulic circuits blind
all holes with plugs.
Collect drained oil; do not leave it soak into the
soil.
Used oil is environmentally dangerous waste -
have them liquidated.
To Next Page
Loading...
