79ASC110/ASC130/ASC150/ASC200/ASC250
OPERATING INSTRUCTIONS
Box (59)
Fold out the back wall of the seat to use the box to store
operation manual.
Heating control (61)
Amount of liquid flowing to the heating radiator can be
infinitely controlled from fully closed (valve closed) to fully
open valve.
Adjust the heating valve before
driving!
Seat switch
The seat switch is located in the seat squab.
The function of the seat switch is activated when the driver
leaves its seat during the ride. Afterwards, speed will
decrease until the dead stop, which takes for 3 seconds.
After another 5 seconds, the roller brakes to a stop and the
engine stalls.
For subsequent engine start, the driver must sit down,
move the travel control device to the neutral position, and
switch on the brake switch. Before starting, it is necessary
to turn off the key to ”0” position and then it is possible to
start up the engine. Before run-up, release the brake by
switching-off of the switch.
If the driver sits down before 3 seconds pass, the roller
keeps on going in selected speed.
If the driver sits down after the roller stopping until 5
seconds pass, the engine does not stall and it does not
brake to a stop and the driver can again drive off. Before
that, the driver must move the control device to the neutral
position and again select the original driving direction.
To Next Page
Loading...
