Ammann ASC 70 - 3.6. Lubrication and Maintenance

107ASC70
850
ENG RPM
100
ENG HRS
28°C
COOL TEMP
1 bar
OIL PRESS
396013B
Carry out lubrication and maintenance on regular basis and re-
peatedly in the intervals as per daily reading on the counter of
hours actually worked.
3.6. Lubrication and Maintenance
This Manual states only the basic information about the engine,
other data are given in the Engine Operation and Maintenance
Manual which is part of the Documentation supplied with the
Machine.
Tighten the removed or loosened bolts, plugs, threaded joints
of the hydraulics, etc. with tightening torque according to the
Chart in par. 3.6.38. unless another value is provided with the
respective operation.
Following the rst 100 hours of operation of the new Machine (following a major overhaul) carry out
as per:
3.6.22. Wheel bolts tightening check
3.6.24. Oil in the travel gearboxes change
Following the rst 500 hours of operation of the new Machine (following a major overhaul) carry out
as per:
3.6.28. Oil in the vibrator change
Carry out maintenance with the Machine
placed on at, paved surface, and secured
against any self-motion, always with the
engine o, and key removed from the ig-
nition box and with the wiring cut o (un-
less otherwise required).
Follow also the instructions given in
the engine operation and maintenance
manual!