Ammann ASC 70 - 2.8. How to transport the Machine

81ASC70
3 3
2
2
1
1
396341
OPERATION MANUAL2.8. How to transport the Machine
• The machine can move on its own between working sites.
When moving on the working site, ob-
serve the safety measures applicable to
the working site.
When driving for long distances, 1-hour
cooling breaks after 3 hours of driving
should be taken. Failing that, you are ex-
posed to the risk of damage to the ma-
chine for which the manufacturer is not
responsible.
Make sure the transport carrier is braked
and mechanically secured against unde-
sired motion with scotch blocks (3) when
loading or unloading.
When moving onto the transport carrier
you must switch ON the function of Drum
Slip Limitation. At the same time we rec-
ommend to put rubber bands or wooden
planks, etc. underneath the drum.
The machine on the vehicle must be
properly tied and mechanically secured
against longitudinal and lateral displace-
ment as well as against tipping (1). The
drums must be secured using scotch
blocks (2). The maximum permitted force
for fastening the machine to a vehicle us-
ing rear slings is 5 t.
• When on the road, the machine should be transported on
a vehicle.
When transporting the machine on a vehi-
cle, observe the regulations in force in the
given territory.