Ammann ASC 70 - Travel and Reversing

67ASC70
100
220
180
250
J1939
°C
396303A
1
A
2
F8
F7
F6
F5
F4
F3
F2
F1
IDLE
277012C
7
11
1
2
3
396066B
4
1
2
3
396065B
6
4
3
OPERATION MANUAL
2.7.2. Travel and reversing
Give acoustic signal for Machine started
to move, and wait long enough so any per-
sons present could leave the area within
Machine vicinity (under the Machine) in
time!
Before starting to move, please conrm
the area in front and behind the Machine
is free and that no persons are found
therewithin!
• Switch ON vibration amplitude (1), indicator lamp (2) will
light.
• Switch OFF IDLE (11) and engine rpm to max. 2200 min
-1
via
gas actuator (7).
• Fasten the seat belt.
• Change the working/transport speed switch (4) to an appro-
priate range of the working speeds “1”–“3” – this activates the
working speed.
• Use the switch (3) to disengage the brakes. The parking brake
indicator lamp (A) goes o.
• Start moving the Machine and turn ON the vibration via
switch (6) - you can stop the vibration by pressing and relea-
sing the pressbutton.
Note
The working speed “1”–“3” can be selected with the switch (4)
while driving.
When driving uphill, set the switch (4) to
“3” to achieve the maximum tractive force
(gradeability) of the machine.
• By switching the transport speed “4” with the switch (4), you
turn on the working speed – vibration is disabled.
Note
The transport speed “4” can be enabled and disabled while dri-
ving.
If the tractive force is insucient while going uphill, change the
switch to the working speed “3”.
Before driving downhill, turn o the
transport speed “4”.