Ammann ASC 70 - Page 72

68 ASC70
MAX
15%
MAX
25%
28245T3
274003A
D MAX 40 %
HX MAX 40 %
274004A
D MAX 45 %
HX MAX 60 %
2.7. Machine control and use
For the maximum permissible slope gra-
dient when driving uphill and across the
slope gradient, see gures.
The values given are lower depending on
adhesive conditions and the machine in-
stantaneous weight!
Do NOT load engine at full capacity until it
reaches 60°C (140°F) temperature.
Do not turn o the transport speed at a
high speed – it will cause sudden slow-
ing down and an impact in the hydraulic
system. Switch o the transport speed at
a low speed or when the machine is at a
standstill!