Ammann ASC 70 - Forbidden Activities - Safety and Guarantee

25ASC70
OPERATION MANUAL
2.1.4. Forbidden activities – safety
andguarantee
Banned are the following
• Vibrating on the spot. When it is vibrated on the spot, bea-
rings of the vibrator are not lubricated.
• Filling the hydraulic circuit during the guarantee period in a
dierent way than using the hydraulic unit.
• Changing the vibration amplitude when driving – It is alwa-
ys necessary to stop and only then set a dierent amplitude.
• Using the machine in case of an evident defect of the ma-
chine.
• Using the machine when any operating uid level is low.
• Wilful repair of the engine – Except common changes of
operating uids and lters, only the Cummins service de-
partment can intervene in the engine, in particular in peri-
pheral components of the engine – alternator, starter, ther-
mostat, electrical installation of the engine.
• Controlling the heating valve control rod while driving.
• Quickly increase and decrease engine speed. It can damage
the engine.
• Use the emergency brake for turning o the engine during
normal operation of the machine.
• Operate the machine in the explosive environment and
underground.
• To use the Machine following ingestion of alcoholic
bewerages or dopes.
• To use the Machine if its operation might put its technical
condition, safety (life, health) of persons, facilities or objects,
or road trac and its continuity, at risk.
• Put into operation and use the Machine when other persons
are within its hazardous reach - exception is training adriver
by lector.
• Put into operation and use the Machine when some of its
safeguarding device (emergency brake, driving brake, horn,
etc.) has been dismantled or damaged.
• To roll and compact at such slopes where Machine stability
would be disrupted (turning over). Machine’s static stability
stated will lower by drive’s dynamic eects.
• To roll and compact at such angles of slopes where hazard
of soil breaking o (dropping) under the Machine exists, or
loss of adhesion followed by uncontrolled slip might occur.
• To control the Machine in some other way than stated in Dri-
ving Manual.
• To roll and compact per bearing capacity of subsoil at such
adistance from the edge of slope or trenches, where hazard
of landslide or shoulder breaking o (dropping) together
with the Machine would occur
• To roll and compact with vibration at such adistance from
the walls, cuts, slopes, where their slip (slide) would happen
and the Machine covered in.
• Driving with vibration on hard (frozen, concrete, overcom-
pacted) surface or on bedrock. There is a danger of damage
to the machine. 
• To compact with vibration at such adistance from buildings
or facilities and equipment within which the risk of them be-
ing damaged due to vibration transfer impact, would occur.
• To operate the Machine unless driver control stand xed pr-
operly.
• To operate the Machine when engine bay cover is open.
• To move and transport persons on the Machine.
• To operate the Machine when within hazardous reach the-
reof are other machines or transportation means aside from
those that operate in mutual concert with the Machine.
• To operate the Machine at places impossible to see from
driver’s stand, and where hazard to people or property
could occur unless work safety has been secured through
some other way like for instance via signalling by duly in-
structed person.
• To work with the Machine at aprotected zone of electric li-
nes or substations.
• To cross electric cables if these are not properly protectedli
against mechanical damage.
• To operate the Machine under lowered visibility or at night,
unless Machine’s working area and workplace are illumina-
ted suciently.
• To leave driver’s cockpit of the Machine when the Machine
is running.
• Boarding or or getting o while on the run, jumping o the
Machine.
• Sit or stand on the outside parts of the Machine when dri-
ving, or stand on the steps.
• Leave unsecured Machine - move away from the Machine
without having prevented its misuse.
• Disable safeguarding, protective or locking systems or alter
their parameters.
• Use the Machine with oil, fuel, cooling liquid or other llings
leaking.
• Start the engine through some other way than given in the
Driving Manual.
• Locate some other items (tools, accessories) aside from per-
sonal needs at driver’s stand.
• Lay away material or other objects on the Machine.
• Remove dirt while the Machine is running.
• Perform maintenance, cleaning or repairs with the Machine
not secured against spontaneous move or accidental start,
and when contact of aperson with moving parts of the Ma-
chine is not excluded.
• Contact of moving parts of the Machine with human body
or objects and tools held in hands.
• Smoke or handle open re when checking or pumping fuels,
relling oils, lubricating the Machine, or inspecting the accu-
mulator or making up the accumulator.
• Carry rags soaked with ammable materials, or carry am-
mable liquids in free vessels on the Machine (in engine bay).
• Let the engine run inside conned spaces.
• Drive with open doors.
• Perform any adjustments on the machine without the prior
consent of the manufacturer.
• Drive without the seat belt fastened.
• Shift electrical conductors.
• Use other than original spare parts.
• Interfere in the electrical and electronic units in any manner.
! NOTICE !
Breaching these provisions can inuence the judge-
ment of a possible complaint and eectiveness of
the engine guarantee period.