Ammann ASC 70 - Page 70

66 ASC70
2
4
3
–
+
+
–
0
v
24
1
2
4
3
396062
0
v
24
2.7. Machine control and use
When using auxiliary starting source this power supply sha-
ll have starting voltage of 24 V.
How to start via starting cables from dierent machine
1. Connect one end (+) of cable pole to (+) pole of dis-
charged battery.
2. Connect second end of (+) cable pole to (+) pole of the
Machine battery from which starting will be made.
3. Connect one end of (-) pole to (-) pole of vehicle battery
with the help of which starting will be made.
4. Connect second end of (-) cable pole to such part of the
Machine being started which is wired in the engine (or
eventually in the engine block itself).
Observe unconditionally the sequence of
operations given below!
Once started, disconnect the starting ca-
bles in reverse sequence.
When having used starting unit with
no batteries connected do not discon-
nect this unit before Machine’s battery is
connected.
Do NOT connect cable of (-) pole to (-) pole
of discharged battery of started Machine!
Strong sparking followed by explosion of
gas generated by the battery may occur
when starting.
Non-insulated parts of starting cable
collets may not touch each other!
Starting cable connected to battery (+)
pole may not come into contact with elec-
trically conductive parts of the Machine -
short-circuit possible.
Do NOT bend over the battery - hazard of
acid burn!
Eliminate presence of ammable sources
(open re, burning cigarettes, etc.).
Do NOT check presence of voltage in wires
with the use of sparking via Machine
frame!