Ammann ASC 70 - Page 120

116 ASC70
396203A
3.6. Lubrication and Maintenance
• When oil is replaced start the engine for 2 - 3 minutes. Check
regularly the tightness of drain plug and lter. Following en-
gine stop you must wait 5 minutes until oil ows down to
the engine sump. Then check oil level with dipstick.
! CAUTION !
Replace oil after 3 months at the latest, even though
250 hours have not been actually worked. Exchange
oil at the interval that comes rst.
Use recommended lters only, refer to the Spare
Parts Catalogue. Use recommended oils, refer to par.
(3.2.1.).
Retain the oil drained, and do not let it
seep into ground.
Used oil and lters are environmen-
tally hazardous waste - hand it over for
disposal.