Page 46
8.6 I/O
Press To display the Manual I/O Control menu
MANUAL I/O CONTROL
0: INPUT 1 :OUTPUT
2: REMOVE ALL MANUAL CONTROL
SELECT NO.
AC:3Z ALM:0 PALM:0 FLT:0 DIS:0
Figure 60: The Manual I/O Control Menu
Manual I/O control allows the technician to turn ON or OFF inputs and outputs off a device to facilitate
testing or isolation of plant during maintenance. Removal of manual control returns control to the
panel.
Press Input Selected:
MANUAL INPUT CONTROL
0:IN A PANEL 1 :ON A LOOP
2:ON A LOCAL ADDON MODULE
3:REMOVE ALL MANUAL INPUT CONTROL
SELECT NO.
AC:3Z ALM:0 PALM:0 FLT:0 DIS:0
Figure 61: The Manual Input Control Menu example
Press
IN A PANEL: Enter the I/O Controller number then the input number. This will display the
description for the input and its current state, you can then turn the input ON or OFF or remove
manual control.
ON A LOOP: Enter the loop number, the device number and the input number. This will display
the description for the input and its current state, you can then turn the input ON or OFF or remove
manual control.
ON A LOCAL ADDON MODULE: Will bring up the list of Modules that have inputs. These can
then be manually turned on and off with the exception off the MCP configured input
LOCAL ADDON MODULE INPUT
1: BRIGADE
2: 16WAY INPUT BOARD
SELECT NO.
AC:3Z ALM:0 PALM:0 FLT:0 DIS:0
Figure 62: Addon Module Input Controls example
Remove All Manual Input Control: Will remove all manual input control.
Output Selected: Same sequences as above for inputs but substitute outputs for inputs.
Remove All Manual Control Selected: Globally removes all manual control.
To Next Page
Loading...
