Page 1
1 About This Manual
1.1 Introduction
This manual contains all the information required to install, commission and operate the FireFinder
PLUS Fire Alarm Control Panel (FACP) and is only available to and for the use of personnel engaged
in its installation, commissioning and operation.
1.2 General Requirements
The FireFinder PLUS FACP has been designed and manufactured from high quality commercial
components so as to comply with major world standards. To ensure these standards are not
compromised in any way installation staff and operators should;
✓ Be qualified and trained for the task they undertake;
✓ Be familiar with the contents of this manual prior to the installation, commissioning or operation
of a FireFinder PLUS control system;
✓ Observe anti-static pre-cautions at all times; and
✓ Be aware that if a problem is encountered or there is any doubt with respect to the operational
parameters of the installation the supplier should be contacted.
1.3 References
ConfigManager PLUS: Operation Manual
Apollo: Detector / Device Manuals
Ampac: Product Data Sheets
Australian Standard:
AS7240 - 2: 2004 Control and Indicating Equipment
AS7240 - 4: 2004 Power Supply Equipment
AS4428 - 3: 2010 Fire Brigade Panel
1.4 Symbols
Important operational information
Note: Configuration considerations
Observe antistatic precautions
Mains supply earth
DANGER mains supply present
To Next Page
Loading...
