Ampac FireFinder PLUS - Page 82

Page 75
Fault: If configured the screen format for reporting loop / device / zone fault condition is:
Zzzz FAULT
<zone descriptor>
<date> <time> CONTROL*
FAULT XXX OF XXX DEVICE►
Note: The fault types only relate to devices.
In the event of a loss of communications, for a period of greater than 15 seconds the SmartTerminal
will default to the No Communications screen. The format for this screen is:
No Communication
Device Isolate / Disables: If configured the screen format for reporting loop / device / zone disable
condition is:
Zzzz DISABLED
<zone descriptor>
<date> <time> CONTROL*
ZONE DISABLED XXX OF XXX DEVICE►
Pre-alarm: If configured the screen format for reporting loop / device / zone Pre-alarm condition is:
Zzzz PRE-ALARM
<zone descriptor>
<date> <time> CONTROL*
ZONE PRE-ALARM XXX OF XXX DEVICE►