Photo 2.5.4
3. Carefully move the carriage and the wiper blade tool toward the wiper blade. The wiper blade
should touch the bottom tip of the wiper height tool. See image 2.5.5 below.
............................................................................................................................................................
............................................................................................................................................................
Photo 2.5.5
.... 4. If the wiper blade is too low or too high you want adjust the wiper blade by loosening the lock
screws on the left and right hand side. See image 2.5.6. Once the lock screws are loosened you
can adjust the height of the wiper blade with the adjustment screws. Moving the adjustment screw
counter clockwise will drop down the wiper blade and moving the adjustment screw clockwise will
raise the wiper blade. Its Very important that both sides are even. There will be an Adjustment
screw on the left and right hand side. Once the wiper blade has been adjusted to the required
height, lock the position in place by re tightening the lock screws. See image 2.5.7
To Next Page
Loading...