5-2 General Measurement Setups LTE Signal Analyzer
5-2 PN: 10580-00234 Rev. T 3GPP MG
4. Press Sync then the Sync Type submenu key to select between the Normal (SS) or RS
for synchronization. RS should be selected ONLY when there is no sync signal. This
happens only when directly connected to a base station that is configured such that one
of the antenna ports does not have a sync signal. When RS is selected, the Cell ID
submenu key becomes active. Enter the Cell ID of the base station. The Cell ID field is
automatically populated with the last measured Cell ID for user convenience.
5. Press Back to return to the Setup main menu.
Antenna Status
The Antenna Status indicator can show when antennas are detected and which one is
currently being measured. Antenna Status is displayed for any EVM measurement shown:
Constellation, Control Channel Power, Modulation Summary and LTE Summary. The
antennas icons are displayed at the lower-left corner of the display screen (Figure 5-1).
Note Sync Type RS is only supported when BW is set to 10 MHz.
Figure 5-1. Antenna Status
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com
To Next Page
Loading...
Need help?
General
