WiMAX MG PN: 10580-00236 Rev. D 1-1
Chapter 1 — General Information
1-1 Introduction
This Measurement Guide documents WiMAX signal analysis for the following Anritsu
instruments:
• BTS Master
• Cell Master
• LMR Master
• Spectrum Master
1-2 Overview
Fixed WiMAX
Fixed WiMAX signal analysis is described in Chapter 2, “Fixed WiMAX Signal Analyzer”.
• Option 0046: Fixed WiMAX RF Measurements
• Option 0047: Fixed WiMAX Demodulator
• Option 0885: WiMAX Fixed/Mobile Measurements (requires Option 9)
Instruments with these options can measure both FDD and TDD Fixed WiMAX networks.
They can measure Fixed WiMAX BTS transmitter performance over the air by connecting an
antenna to the instrument or by connecting the BTS equipment directly to the instrument.
Mobile WiMAX
Mobile WiMAX signal analysis is described in Chapter 3, “Mobile WiMAX Signal Analyzer”.
• Option 37: Mobile WiMAX Over-the-Air (OTA) Measurements
• Option 66: Mobile WiMAX RF Measurements
• Option 67: Mobile WiMAX Demodulator
• Option 0885: WiMAX Fixed/Mobile Measurements (requires Option 9)
Instruments with these options can measure TDD Mobile WiMAX networks. OTA, RF, and
demodulator measurements require that an antenna be attached to the RF In (50 Ohm)
connector on the instrument.
Attach a coupler or attenuator to the same connector to make measurements directly from
the WiMAX BTS transmitter.
Note
Not all instrument models offer every option. Please refer to the Technical Data
Sheet of your instrument for available options.
Caution
The maximum (without damage) input level of the RF In port is +30 dBm. To
prevent damage, always use a coupler or a high power attenuator.
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com
To Next Page
Loading...
