3-6 Mobile WiMAX OTA Measurements Chapter 3 —Mobile WiMAX Signal Analyzer
3-14 PN: 10580-00236 Rev. D WiMAX MG
3-6 Mobile WiMAX OTA Measurements
The Over the Air (OTA) Measurement option displays a Channel Power Monitor and
Preamble Scanner.
Setup for Measurements Setup
1. Press the Measurements main menu key.
2. Press the OTA submenu key to open the Over-The-Air submenu.
Channel Power Monitor
This measurement displays the Channel Power (RSSI) value over a period of time that you
specify. You can also specify the time interval between channel power measurements. Time
stamps are recorded along with the power information. If GPS is activated on the instrument,
then UTC time is stored, and GPS coordinates are also stored. If GPS is not activated on the
instrument, then the internal clock is used.
1. Press the Channel Power Monitor submenu key to select the Channel Power Monitor.
2. Set the Measurement Interval and Auto Save features as desired.
3. Press the Reset/Restart Measurement key to discard logged Channel Power data and
restart logging of the data.
Figure 3-11. Mobile WiMAX OTA Channel Power Monitor Measurement
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com
To Next Page
Loading...
