ANthony 101 - Torque Rod Replacement (1987 to 1991); Torque Rod Replacement (1991 to Present); Front Bumper Bar Field Installation

Model 101/2100 Doors Service & Installation
TITLE:
99-13312-S001 Model 101/2100 Doors Service & Installation
REV.
B
Page 28 of 95
5. Replace hinge side cover plate.
6. Re-install door.
28. Torque Rod Replacement (1987 to 1991)
1. To remove torque rod, use flat-head screwdriver. Catch edge of torque rod shaft and
tap rod down and out through bottom of door.
2. Reverse instructions to replace.
29. Torque Rod Replacement (1991 to Present)
1. To remove torque rod, use flat-head screwdriver. Catch edge of torque rod shaft with
screwdriver and tap rod down into place (Door Quick Disconnect and Reversing).
2. To replace, slide end of rod up hinge rail, then insert square shaft of torque rod into
square hole in door rail. Tap into place.
Note: Torque rod has no tip.
30. Front Bumper Bar Field Installation
Front Bumper
Bar
1. Order door guards 1” smaller than actual door width.
2. Specify finish (Gold/Silver).