ANthony 103 - User Manual

To Next Page

Model 101 & 2100

(Including Pass-Thru Door Models 103, 105,

107, 2125, 2127, 2130)

Service & Installation

November, 2012

99-13312-S001

Main Page

Table of Contents2
Models 101 & 2100 Door & Frame - Reversible Parts Placement (Start 10/89)6
Models 101 & 2100 Reversible Door Parts Placement (1989 to 1991)7
Models 101 & 2100 Standard (before 7/94) Frame Net Opening Widths8
- 24" Door (Catalog Size) 23-3/16" Actual Door Width8
- 26" Door (Catalog Size) 26-3/8" Actual Door Width8
- 30" Door (Catalog Size) 29-7/8" Actual Door Width8
Models 101 & 2100 Standard Frame Net Opening Heights9
Models 101 & 2100 Frame Installation9
Frame Divider Board Installation (Prior to 1993)10
Reversible/Cordless Door & Hold-Open Installation11
Reversing Frame Hardware12
Door Reversing Instructions Models 101 & 2100 (1989-1991)13
Door Reversing Instructions (1991 to Present)16
Models 103, 105, 107, 2125, 2127 & 2130 Pass-Thru Installation17
Frame Sill Plastic Protector Installation Models 101 & 210019
Contact Plate and Contact Plate Retainer Replacement20
Ordering Replacement Doors21
Torquemaster Replacement22
Door Gasket Replacement22
Door Plastic (Cover) Replacement23
Door Cut-Away & Handle Replacement23
Side Access Plate Replacement (1989 to 1991)24
Side Access Plate Replacement (1991 to Present)24
Door Female Plug Replacement (1989 to 1991)25
Frame Female Plug And/Or Socket Replacement (1991 to Present)25
Door Heater Replacement (1989 to 1991) Model 101 Only26
Door Heater Replacement (1991 to Present) Model 101 Only26
Wiring Instructions, Heated & Non-Heated Glass (1991 to Present)27
Hinge Pin Replacement (1989 to 1991)27
Hinge Pin Replacement (1991 to Present)27
Torque Rod Replacement (1987 to 1991)28
Torque Rod Replacement (1991 to Present)28
Front Bumper Bar Field Installation28
Model 101 Door Cylinder Lock Replacement or Repair29
Lock Installation30
P.O.M. Lock Installation31
Model 101 Glass Replacement (Reglazing)32
Title: Rev33
Ordering Replacement Frames35
Frame Heater Wire Replacement36
Models 101 & 2100 Frame Heater Schematic/Low Temp37
Models 101 & 2100 Frame Heater Schematic/Normal Temp37
Humastat Installation Procedure38
Title: Rev39
Model 101 Humastat40
Model 101 & 2100 Shelf Assembly Catalog Size/Shelf Size40
Models 101 & 2100 Frame & Shelving with Standard Lighting42
Models 101 & 2100 Frame & Shelving with "ELS" Electronic Lighting43
Four-Post Stabilizer Bar Installation46
Four-Post Shelf System Installation46
Title: Rev47
Plastic Tag Molding Installation48
Model 2100 G.F.I. Location & Wiring Diagram49
Lamp Replacement49
Lamp Socket Replacement50
Recessed Light Socket Replacement51
Recessed Lamp Channel Replacement with Remote Ballast51
Boost & Buck" Transformer Wiring Diagram52
Recessed Lamp Guard Replacement with Remote Ballast52
Recessed Lamp Replacement52
Frame Junction Box Wiring (Standard Production)53
Models 101 & 2100 Light Fixture Placement (Prior to 10/93)53
Models 101 & 2100 Light Fixture Placement - "Continuous" Lineup (10/93 to Present)54
Models 101 & 2100 Low Temp 120-Volt Remote Ballast and Lamp Wiring Diagram for 1-Light Systems55
Models 101 & 2100 Low Temp 120-Volt Remote Ballast and Lamp Wiring Diagram for 2-Light Systems55
- Title: Rev56
- Title: Rev57
Models 101 & 2100 Normal Temp 120-Volt Remote Ballast and Lamp Wiring Diagram for 1- & 2-Light Systems59
Models 101 & 2100 Normal Temp 120-Volt Remote Ballast and Lamp Wiring Diagram for 3-Light Systems59
Normal Temp & Low Temp 120-Volt Ballast and Lamp Wiring Diagram - Pre-Wired 1-Light System60
Ballast Replacement60
ELS" Lamp Socket Replacement61
Title: Rev62
ELS" Electronic Ballast Replacement and Wiring Instructions63
- Title: Rev64
- Title: Rev65
- Title: Rev66
- Title: Rev67
- Title: Rev69
Lamp Replacement Instructions69
- Title: Rev70
- Title: Rev71
- Title: Rev72
- Title: Rev73
- Title: Rev74
Dew Point Chart75
- Standard Lighting (Per Door, with Doors Closed @ 75°F Store Ambient)80
Heat Load in Btu/Hr for Model 101 Normal Temp Glass, Door Rail, Frame Heaters and80
Heat Load in Btu/Hr for Model 2100 Low Temp Glass, Door Rail, Frame Heaters and Standard Lighting (Per Door, with Doors Closed @ 75°F Store Ambient)82
Electrical Information for Model 2100 Low Temp Heated Doors, Frames & Standard Light Fixtures Heater Amperages @ 120 Volts83
Electrical Information for Model 2100 Normal Temp Doors, Frames & Standard Light Fixtures Heater Amperages @ 120 Volts84
- And Standard Lights (Per Door, with Doors Closed @ 75°F Store Ambient)85
Heat Load in Btu/Hr for Model 101 Low Temp Glass, Door Rail, Frame Heaters and "ELS" Electronic Lighting System (Per Door, with Doors Closed @ 75°F Store Ambient)86
- Electrical Information for Model 101 Low Temp Doors, Frames & "ELS Electronic Lighting System Heater Amperages @ 120 Volts87
- Electrical Information for Model 101 Normal Temp Doors, Frames & "ELS" Electronic Lighting System Heater Amperages @ 120 Volts88
- ELS" Electronic Lighting System (Per Door, with Doors Closed @ 75°F Store Ambient)91
- Electrical Information for Model 2100 Low Temp Doors, Frames & "ELS" Electronic Lighting System Heater Amperages @ 120 Volts92
Heat Load in Btu/Hr for Model 101 Normal Temp Glass, Door Rail, Frame Heaters and "ELS" Electronic Lighting System (Per Door, with Doors Closed @ 75°F Store Ambient)91
Heat Load in Btu/Hr for Model 2100 Normal Temp Glass, Door Rail, Frame Heaters and "ELS" Electronic Lighting System (Per Door, with Doors Closed @ 75°F Store Ambient)93
Heat Load in Btu/Hr for Model 2100 Low Temp Glass, Door Rail, Frame Heaters and "ELS" Electronic Lighting System (Per Door, with Doors Closed @ 75°F Store Ambient)94
Troubleshooting96
Safety Precautions98
Tips98

Brand	ANthony
Model	103
Category	Commercial Food Equipment
Language	English

ANthony 103 - User Manual

Table of Contents

Summary

Models 101 & 2100 Frame Installation

Reversible;Cordless Door & Hold-Open Installation

Door Reversing Instructions (1991 to Present)

Models 103, 105, 107, 2125, 2127 & 2130 Pass-Thru Installation

Torquemaster Replacement

Door Gasket Replacement

Door Heater Replacement (1991 to Present) Model 101 Only

Wiring Instructions, Heated & Non-Heated Glass (1991 to Present)

Model 101 Glass Replacement (Reglazing)

Frame Heater Wire Replacement

Humastat Installation Procedure

Models 101 & 21 00 Frame & shelving with Standard Lighting

Models 101 & 21 00 Frame & shelving with “ELS” Electronic Lighting

Lamp Replacement

Boost & Buck Transformer Wiring Diagram

Models 101 & 2100 Low Temp 120-Volt Remote Ballast and Lamp Wiring Diagram for 1-Light Systems

Ballast Replacement

“ELS” Electronic Ballast Replacement and Wiring Instructions

T-8 Lamp Replacement Instructions

Electrical Information for Model 101 Low Temp Heated Doors, Frames & Standard Light Fixtures Heater Amperages @ 120 Volts

Troubleshooting

Safety Precautions

ANthony 103 Specifications

Related product manuals