ANthony 103 - Door Plastic (Cover) Replacement; Door Cut-Away & Handle Replacement

Model 101/2100 Doors Service & Installation
TITLE:
99-13312-S001 Model 101/2100 Doors Service & Installation
REV.
B
Page 23 of 95
2. Model 101 To replace gasket, remove top and bottom door plastic and slide the
gasket up the two verticals. Slide top and bottom plastic onto gasket and
replace top and bottom plastic on door rail. Tuck in corners of gasket with
a flat-head screwdriver.
Model 2100 Lay new gasket over track in back of door rail. With a single-edged plastic
roller, roll in the outside edge of door gasket first, then the inside edge.
Tuck in all four corners.
3. Reverse instructions to replace.
17. Door Plastic (Cover) Replacement
1. Starting in corner, gently pull rubber gasket away from door plastic.
2. With gasket removed, insert flat-head screwdriver under outside edge of plastic and
gently pry up. At either end of plastic, run screwdriver the complete length and width of
door rail. With outside edge of plastic released, push plastic toward glass to remove.
3. To replace, insert inside edge of plastic into inside door rail groove. Snap outside edge
of plastic over outside edge of door rail.
18. Door Cut-Away & Handle Replacement
Handle Replacement Door Cut-Away