circuit.
After checking completed, click [C]to exit.
2.7 T&A status setting
In T&A status, press [←] or [→] key to shift attendance status. System default
statuses are IN, Pass, OUT.
OUT
09 : 00 26
01/13/11 THU
PASS
09 : 00 26
01/13/11 THU
2.8 T&A
FP only mode:
In T&A status, place registered finger on sensor scanner. After a beep ‘di-’, system
will prompt as following,
FP Verify
Take Off!
Remove your finger. If access granted, green LED indicator will be on with voice
prompt ‘Access granted’. And interface displays as following,
FP Verify
ID 008101
Verified！
If access fails, red LED indicator will be on with voice prompt ‘Access denied’. And
interface displays as following,
FP Verify
Input Again！
ID+ Password mode:
28
To Next Page
Loading...
