Legacy AXS API
Just to the right of the VU meters, there is a set screw adjustment. This adjustment is to rock
or tilt the signal left or right when in the auto gain mode, allowing subtle corrections in the stereo image
if it is off center when compressing. This control only affects the image when the 25OO is above the
threshold, and does not do anything when the signal is not being compressed. Usually, this control
should be in a vertical position.
One tip to get started: We try to design all of our processing modules with the understanding that there
is never enough time to read a manual and learn all of the features in the 10 seconds that is allowed
during a setup. If you simply place all of the knobs at the 12:OO position, the 25OO, and all of the 2OO
series modules will have a useful, but conservative effect on the signal.
To Next Page
Loading...
