Frame lines + status info screen
Frame lines Select to set frame lines to On or Off. Frame lines
are a reference for framing that typically consist
of an image frame, a center mark and an aspect
ratio reference. See the appendix for more
information on the ALEXA frame line format.
Surround mask Select to adjust the Surround mask settings. If
surround view is set to "On", it must be separated
from the recorded image area to allow proper
framing. Users can choose:
Black line
Color line
Mask 25%
Mask 50%
Center mark Select to set the Center mark to Off, Small Dot,
Medium Dot or Cross to aid in image framing.
Status info Select to set Status info to On or Off. When set to
On, camera shooting parameters are displayed
across the top of the EVF-1’s image, outside the
active image area and camera status information
is displayed across the bottom of the EVF-1’s
image, outside the active image area.
Electronic
horizon
Select to set the electronic horizon level to On or
Off.
Only available on ALEXA Plus, ALEXA Plus 4:3,
ALEXA Studio, ALEXA M, ALEXA XT Plus, ALEXA
XT M, ALEXA XT Studio and ALEXA HD Plus.
LDS info Overlay showing LDS lens info.
Only available on ALEXA Plus, ALEXA Plus 4:3,
ALEXA Studio, ALEXA M, ALEXA XT Plus, ALEXA
XT M, ALEXA XT Studio and ALEXA HD Plus.
MON OUT
The MON OUT is a 422 1.5G single link HD-SDI output. The output
range is fixed at legal range.
Frame rate Select to set the MON OUT frame rate to 23.976,
24, 25, 29.97 or 30 fps. The frame rate should, if
possible, match the sensor frame rate to avoid
dropped frames or duplicate frames on the
output, which would result in jittery images
during camera movement or when image
subjects are moving.
Scan format Select to set the type of scan:
p: Progessive. Images are transmitted line
To Next Page
Loading...
Need help?
General
