8 Camera Support
8.1 Minimum Equipment
Recommended For Operation
ARRI ALEXA camera body including SxS module or XR module
and Lens Adapter PL mount without LDS (LA-PL-1)
Electronic Viewfinder EVF-1
Viewfinder Mounting Bracket
KC 150-S Viewfinder Cable short 0.35m/1.2ft
CCH-1 Center Camera Handle
BP-12 Bridge Plate with base plate, or BPA-1 with BP-5/BP-8
Bridge Plate and base plate, or WA-1 Wedge Adapter and Quick
Release HD Baseplate
SD card
Compatible power supply
Suitable media for recording
8.2 Tripod and Remote Heads
Tripod and remote heads must have adequate load ratings to support
the ALEXA and attached accessories. See the following table for
camera and component weights.
Note: Always check the payload limits of a remote head and crane before
mounting a camera.
In applications where the camera mount is subject to high forces (e.g.
car or helicopter mounts) the camera must be additionally secured with
appropriate safety restraints. All mount screws must be tightened
firmly with an appropriate screwdriver (not with the commonly used
coin!).
Camera weight lb kg
ALEXA camera body weight with SxS module 13.8 6.3
ALEXA camera setup weight with SxS module
(incl. EVF-1, VMB-1, CCH-1, KC-150S)
16.9 7.7
ALEXA camera body weight with XR module 14.5 6.6
To Next Page
Loading...
Need help?
General
