4. To apply a custom name to your user setup, press the RENAME
button. Erase the default user-setup name by pressing the CLEAR
ALL button.
5. Use the jogwheel to enter a new name by scrolling to the desired
character and pressing to select it.
6. When you have finished entering the new user setup name, press
the DONE button.
7. Press the jogwheel to save the new user setup to the SD card.
To load a user setup:
1. Press the MENU button.
2. Use the jogwheel to select User Setups.
3. Select Load setup.
4. Use the jogwheel to select the desired setup in the list and press the
jogwheel to load the setup.
5. Press the PROJECT button to validate your project settings.
Note: User setups work only in the SUP version they are created in. After a SUP
update, a new user setup must be created and saved.
A recommended procedure for working with user setups is as follows:
1. Before shooting, perform a factory reset to restore factory default
settings.
2. Save a user setup named "Reset" or similar. This will be used
instead of performing the ALEXA’s factory reset.
3. Adjust the camera's shooting parameters and settings, and load the
desired frame lines and ARRI Look Files.
To Next Page
Loading...
Need help?
General
