Arturia beatstep pro - Front-Panel Parameters

10.6.2. Front-panel parameters
Most of these parameters have been covered extensively in the Step Sequencer [p.24]
chapter:
However, the Transpose parameter is even easier to use inside the MIDI Control Center than
it is from the front panel. See the Transpose parameter [p.98] section below for information
on that.
To edit Swing %, for example, click and drag the knob graphic or double-click in the value
field and enter a new value:
To edit a parameter such as Playback Direction, click its pull-down menu and make a
selection:
10.6.2.1. Transpose parameter
This parameter allows you to transpose the entire pattern up or down chromatically over a
range of +4/-3 octaves without having to select the notes and drag them to new places in
the piano roll window.
Front-panel parameters for SEQ1 and SEQ2
Editing a knob value
Selecting a pull-down
menu option
Arturia - User Manual BeatStep Pro - MIDI Control Center 98