2.4. Project Save
Your patterns can be lost unless you save the Project that contains them. Saving a Project is
simple! It only takes three steps.
!: When you follow these instructions you will overwrite the selected Project and all of its patterns.
Be sure this is what you want to do! If not, be sure to find out which memory location is available and
store the Project there instead.
Once you’re sure where you want to store the Project,
• Hold the SAVE button
• Press the PROJECT button and hold it
• Press the Step button number you chose earlier.
The next time you want this Project, that’s where it will be.
It’s also a good idea to back up the Project and patterns using the MIDI Control Center [p.84].
The Store To/Recall From [p.92] section will tell you what you need to know about that.
♪: Individual sequences and Drum patterns should be saved often during creative sessions. See
Saving a sequence [p.36] and Saving a Drum pattern [p.48] for these procedures.
Arturia - User Manual BeatStep Pro - Basic Operations 22
To Next Page
Loading...
