9.5. Encoders: CC vs. MCU/HUI mode
There’s a KNOBS button in the Project/Control Mode section also. It toggles the encoders
between their MIDI CC assignments in Control Mode and their MCU/HUI protocol
assignments.
For a detailed list of these assignments, see the list in the MCU/HUI encoder assignments
[p.129] section of the Parameter Charts [p.125] chapter.
9.6. Shift functions in Control Mode
There are several Global settings that can be toggled from within Control Mode using the
SHIFT button and one of the Step buttons.
Step button combination Global setting
SHIFT + 9 Touch strip = Roller (lit) or Looper (unlit)
SHIFT + 14 Wait to Load Pattern = On (lit) or Off (unlit)
SHIFT + 15 Global tempo (lit) or per-Project tempo (unlit)
These can also be set using the MIDI Control Center [p.84] software.
83 Arturia - User Manual BeatStep Pro - Control Mode
To Next Page
Loading...
