6.1.6.3. Example 1: Velocity offset
1. Select a pattern and set its length to 4 steps.
2. Select the Velocity setting with the KNOBS button.
3. Use encoders 1-4 to change the velocities of the four steps to the values 127, 100,
4, and 50, respectively.
4. Hold [SHIFT] and turn encoder 1until you see a value of 10 in the display.
5. The Velocity values for the four steps should now be 127, 110, 14, and 60,
respectively. This can be confirmed by touching encoders 1-4 briefly.
♪: The offset feature will not allow you to reach velocity values outside of the range 0-127.
6.1.6.4. Example 2: Uniform velocity
1. Select a pattern and set its length to 4 steps.
2. Select the Velocity setting with the KNOBS button.
3. Use encoders 1-4 to change the velocities of the four steps to the values 127, 100,
4, and 50, respectively.
4. Hold [SHIFT] and turn encoder 2 until you see a value of 10 in the display.
5. The Velocity values for the four steps should now all be set to 10. This can be
confirmed by touching encoders 1-4 briefly.
71 Arturia - User Manual BeatStep Pro - Advanced Features
To Next Page
Loading...
