Asante 1012 - Page 92

Index
I-3
R
Rear panel 1-6
Rear panel features 1-6
Rear panel, network connections 1-7
Redundant link selection, setting priorities 1-9
Reset button 1-3
RJ-45 rear panel ports, guidelines 1-8
S
Serial port 1 (RS-232), default settings 1-10
SFD (Start Frame Delimiter) 2
Site requirements 1-14
Site Requirements 3-12
SNMP read community, default setting 1-10
SNMP write community, default setting 1-10
SQE 2-11
Straight-through cabling, use of 2-8
Support for Pre-10BaseT A-1
Switches 1-6
Switches 2-7
SYS contact, default setting 1-10
T
Technical Specifications B-1
TELCO connector 1-6
Temperature, for hub 1-14
Terminal, set switch when using 1-9
Termination
AMS link 1-32, 33
The figure below illustrates the front-panel
LEDs during normal hub operation.Ds,
overview 2-2
Tools 1-12
Troubleshooting 4-1
Twisted-pair x
U
Unpacking the hub 1-14
UTP x