ASCOM D62 - Page 44

Prio 7
14:04
Prio 2
13:59
Prio 2
14:02
Prio 4
14:03
Prio 4
14:03
Prio 4
13:58
Prio 7
14:04
Prio 2
14:02
Prio 2
13:59
New messages
M
essage queue
Prio 4
14:03
Prio 4
13:58
Prio 7
14:04
Prio 2
14:02
Message queue
The user closes
the message
TD 92639EN
08 December 2012 / Ver. H
Configuration Manual
Ascom d62 DECT Handset
39
Figure 5. Describing how queing and prioritizing for messages wit
h equal messages
works
In figure 5, a message with priority 2 is received at 13:59 and is
displayed in the handset.
Another message with equal priority is received at 14:02 and will be placed in the queue
. If
no messages with higher priority are received, the user needs to close the current displayed
message to show the next message in the queue. In this case, the message received at
14:02. The closed message will be indicated as a read message in the Messaging Inbox.
Example 2
This example describes the message handling with
the following message settings:
•
TTP= 20 seconds
• TTR= Close manually
Tip: It is recommende
d to use these settings if the user shall not be interrupted during 20
seconds while reading a message, unless a message with higher priority is received. When
the user has read a message, its priority is no longer important, that is when TTP expires.
Prio 2
New messages
10 sec.
Prio 2
TTP paused
20 sec.
Prio 1
TTP expired
Prio 1
TTP expired
10 sec.
Prio 2
TTP expired
Prio 1
New messages
Prio 2
TTP
continues
Prio 1
TTP started
Prio 2
TTP started
Figure 6.
In figure 6, a message with prio 2 is received and displayed in the hand
set, TTP for the
message is started.
After 10 seconds, a second message with priority 1 is
received and displayed while the
message with priority 2 is put in the queue. TTP for the message with priority 2 is paused,
and TTP for the message with priority 1 is started.