ASCOM D62 - Automatic Alarm Response Configuration

TD 92639EN
08 December 2012 / Ver. H
Configuration Manual
Ascom d62 DECT Handset
48
• Function - Determines the function to be connected to the soft key.
• Value - Determines a value (for e
xample, phone number) to a function. The value is only
needed for some functions.
• Control question - Determines if a Proceed? di
alogue shall appear when pressing a soft
key.
Configure Idle display
groups (sub group)
By default, the name of a system profile is displaye
d in the handset. It is only needed to
configure an idle display group if a system name not shall be displayed in the handset.
Select System Profiles > System Profiles Sub Groups > Idl
e display groups > Idle display
group 1.
• Show name of system profile - Determines if the name of the
system profile shall be
displayed in the handset’s idle screen.
• Name of group - Determines the name of the group
Create System Profile using Pre-defined Sub Groups
In order to create a system profile, it must be connected t
o the pre-defined sub groups.
Select System Profiles > System Profile X.
• Soft keys group - Determines if a soft group shall be used.
• Alarm settings group - Determines if a alarm setting
s group shall be used.
• Presence group - Determines if a presence group shall be used
.
• Idle display group - Determines if an idl
e display group shall be used.
Activate/Deactivate System Profile
When a system profile is created, it can be act
ivated on the handset using PDM/Device
Manager or via an Unite application. For example, the application could be triggered by a
positioning beacon. However, this section describes how to activate the system profile using
PDM.
By default, when the system profile is activated, its nam
e is displayed in the handset’s idle
screen. The system profile name replaces the system name (that is, the DECT system the
handset is subscribed to). If a certain system profile always shall be active on a handset, it is
recommended to hide the settings/menues the user cannot change. If the user changes any
settings that are specified in the system profile, the settings will not be applied.
Example:
In the system profile Al
arm has the alarm settings been configured. In this case, the user
cannot change any alarm settings via the handset, despite that the Alarm menu is visible. It
is recommended to hide the Alarm menu to avoid misunderstanding.
1 Select "System profiles".
2In the Acti
ve system profile on phone drop-down list, select one of the following:
• Normal - no system profile will be used.
• [System profile]