EasyManuals Logo

ASCOM d63 User Manual

ASCOM d63
93 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #90 background imageLoading...
Page #90 background image
TD 93119EN
28 June 2016 / Ver. PA5
User Manual
Ascom d63 DECT Handset
82
SERVICE NEEDED
Invalid IPDI
Note: This display
message is only shown
in English.
Easy replacement procedure not
followed correctly or failure during
easy replacement procedure.
Send the handset for service.
Enter PIN code The handset’s lock is activated. Enter the required PIN code. If
PIN code lost enter new via
WinPDM or do a factory reset
via WinPDM.
Battery low, charge now The battery level is low. Charge or replace the battery.
Phonebook is not
available at the
moment.
The phonebook does not respond,
not available at the moment.
Try again later or if fault
persists do a factory reset via
admin menu or WinPDM.
Voicemail number not
defined
There is no Voicemail number
defined in the handset.
Define a Voicemail number via
WinPDM.
Could not encrypt
connection
The parameter "Encryption
Required" is enabled in the
handset in combination with;
1) Unencrypted base station(s);
and/or,
1) Disable the "Encryption
Required" parameter in
handset; and/or,
2) Unsupported base station(s). 2) Enable the encryption in the
base station(s); and/or,
3) Use supported base
station(s). Ask your supplier.
Not allowed 1) The user cannot login to the
handset with the shared phone
functionality enabled, due to
another handset currently using
the same extension (User).
1) Logout from the handset
that uses the same extension.
2) The user cannot logout from
the handset with the shared
phone functionality enabled, due
to incorrect password (AC code).
2) Enter #11*<AC code># on
the keypad and press the off-
hook key to logout from the
shared phone.
3) The extension (User) does not
exists.
3) Make sure that you entered
correct extension. If needed,
contact the system
administrator.
4) The password is not correct. 4) Make sure that you have
entered correct password. Ask
the system administrator if you
have forgot the password.

Table of Contents

Other manuals for ASCOM d63

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ASCOM d63 and is the answer not in the manual?

ASCOM d63 Specifications

General IconGeneral
Resolution240 x 320 pixels
MessagingSMS
BluetoothYes
Wi-FiNo
LoudspeakerYes
3.5mm jackNo
Operating Temperature-10°C to +55°C
Storage Temperature-20°C to +60°C
Display size2.4 inches
KeypadPhysical keys
BatteryLi-Ion
Display typeTFT LCD
HumidityUp to 95% RH non-condensing

Related product manuals