5757
5757
57
20323163en_ba_a0
Additional settings
Setting the date and timeSetting the date and time
Setting the date and timeSetting the date and time
Setting the date and time
On startup or following a power cut, the time display flashes. The time and date are
automatically updated after the first outgoing call and the time is displayed without flashing.
You can also set the time and date manually. Press the menu key. Press the
right arrow key (>) until »Installation« appears. Press the OK key to confirm.
Press the arrow keys (<) or (>) until »Date/Time« is shown. Press the OK key.
The display shows »Date:« with the current setting and the cursor position
ready for overwriting.
Use the numerical keys to enter the day, month and year. Press OK to confirm.
The display shows »Time:« with the current setting and the cursor position
ready for overwriting.
Use the numerical keys to enter the hours and minutes. Press OK to confirm.
The display again shows date/time. If you do not wish to make another entry,
hold down the ESCAPE key.
Or…
Press the arrow keys (<) or (>) to scroll through this menu.
➭
The date and time are displayed unless there are unanswered calls. As soon as your
Ascom Eurit 25 registers unanswered calls, the call count and time of call are displayed.
Interception circuit (malicious call identification)Interception circuit (malicious call identification)
Interception circuit (malicious call identification)Interception circuit (malicious call identification)
Interception circuit (malicious call identification)
If available, this service must be requested from your network provider. It retains the call-related
data during a call and up to 20 seconds after the handset is replaced. The exchange registers
number, date and time even if the caller has suppressed his number (CLIR). If you have subscribed
to this service you can also activate it using a speed dial key (see »Additional settings« under
»Programming speed dial keys«.
You receive a call and want to register it.
Press the OK key.
Press the right arrow key (>) until the display shows »MCID«.
Press the OK key to confirm.
To Next Page
Loading...
Need help?
General
