TD 92579EN
15 February 2012 / Ver. H
Installation and Operation Manual
IP-DECT Base Station & IP-DECT Gateway (software version 5.0.x)
99
Tip: To assign a PARI Master, see 8.5.23 Enter IP Address to the PARI Master and the
Standby PARI Master on page 99.
1 Select DECT > Radio.
2 Clear the Disable check box.
8.5.23 Enter IP Address to the PARI Master and the Standby PARI Master
All IPBS/IPBL need to know the IP address of the PARI Master and the Standby PARI Master.
1 Select DECT > Radio.
2 Enter the name for the PARI Master in the Name text field.
3 Enter the password for the PARI Master in the Password text field.
4 Enter the address to the PARI Master in the PARI Master IP Address text field. If this
is the PARI Master, enter 127.0.0.1.
5 Enter the address to the Standby PARI Master in the Standby PARI Master IP Address
text field. If this is the Standby PARI Master, enter 127.0.0.1.
6 Click "OK".
7 Reset in order to make the changes take effect, see 8.22 Reset on page 138.
8.5.24 Multiple Radio Configuration
The PARI Master can configure the same Radio settings for all Radios in the system. All
settings configured in the Radio Config page replace the local Radio settings. This means
that all settings in the Radio Config menu will have precedence over values configured
locally or received via DHCP options.
1 Select DECT > Radio Config.
NOTE: To access the Radio Config. tab, the PARI function has to be enabled, see
8.5.15 Enable PARI Function on page 94.
2 Configure alarm and event forwarding, see Forward Alarms and Events on page 70.
3 Configure automatic firmware update, see 8.1.4 Configure Automatic Firmware
Update on page 68.
4 Configure NTP settings, see 8.1.5 Configure the NTP Settings on page 68.
5 Configure IP settings, see 8.3.1 Configure IP Settings on page 81.
6 Click "OK".
8.5.25 PARI
The PARI is a part of the broadcast identity, which uniquely identifies an IPBS/IPBL. This
PARI is automatically assigned to each IPBS/IPBL in the system. But if more than one Ascom
IP-DECT system operates within the same coverage area, the systems need to have a
unique system identity in the PARI assigned in order to differentiate the systems.
To see the occupied system IDs of other Ascom IP-DECT systems within the coverage area,
perform an RFP scan, see 8.21.10 RFP Scan on page 137.
1 Select DECT > PARI.
NOTE: To access the PARI tab, the PARI function has to be enabled, see 8.5.15
Enable PARI Function on page 94.
To Next Page
Loading...
Need help?
General
