TD 92579EN
15 February 2012 / Ver. H
Installation and Operation Manual
IP-DECT Base Station & IP-DECT Gateway (software version 5.0.x)
90
1 Select DECT > System.
Note: To access the System tab, the Master mode has to be activated, see 8.5.13
Select Mode on page 94.
2 Select subscription method in the Subscriptions drop-down list.
3 Click "OK".
Note: When"With System AC" is enabled anyone could register to the IP-DECT System.
8.5.3 Configure Authentication Code
If "allow anonymous subscription" method is selected it is needed for the IP-DECT system
to have an authentication code configured. The authentication code is generated
automatically but can be modified manually by selecting a code consisting of 4 to 8
numbers (0-9).
1 Select DECT > System.
Note: To access the System tab, the Master mode has to be activated, see 8.5.13
Select Mode on page 94.
2 Enter an authentication code in the Authentication Code text field.
3 Click "OK".
8.5.4 Select Tones
1 Select DECT > System.
NOTE: To access the System tab, the Master mode has to be activated, see 8.5.13
Select Mode on page 94.
2 Choose tones in the Tones drop-down list.
3 Click "OK".
8.5.5 Set Default Language
If the handset does not send language information to the system, this setting determine
which language that is displayed for some text messages (for example hung-up and
disconnected).
1 Select DECT > System.
Note: To access the System tab, the Master mode has to be activated, see 8.5.13
Select Mode on page 94.
2 Choose language in the Default Language drop-down list.
3 Click "OK".
8.5.6 Set Frequency Band
The IPBS/IPBL can operate in the following frequency bands:
• 1880 - 1900 MHz, Europe, Africa, Middle East, Australia, New Zeeland and Asia
• 1910 - 1930 MHz, South America
• 1920 - 1930 MHz, North America
Figure 21.
1 Select DECT > System.
NOTE: To access the System tab, the Master mode has to be activated, see 8.5.13
Select Mode on page 94.
To Next Page
Loading...
Need help?
General
